push to start and stop
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132085
Printed Date: May 23, 2024 at 3:18 AM
Topic: push to start and stop
Posted By: jayuk
Subject: push to start and stop
Date Posted: August 28, 2012 at 5:00 PM
Hello my first post but im not new here. I would like some advice on the following.
I have a UK spec Iveco Daily When I got it the half the key was snapped in the ignition. for a new ignition set its going to cost hundreds of £. Im too cheap for that. So what I have done is fixed the only imobliser chip that came with the van to the back of the ignition this serves 2 purposes. 1 no remote bypass will work in my vehicle at all for my remote start (Viper). 2 I want a full keyless go system. The ignition barrel is going to be blocked off.
I have installed a RFID and using the diagram from this site made a normally open ignition cut off for a momentary switch. The RFID basically sends the signal to the relays mantioned above. All works great (thanks to this site)
Now I want to install a push to start button so I can then block off the ignition barrel and have my fully functional keyless go ( ok nearley keyless go the keys need to be in the ashtray ) My question is Can I build a one button set up IE: Push once IGN push twich START push third Engine stop or would it be best to buy a system? I would prefer to press the brake to be able to crank the engine for safety reasons. I did not forget ACC above in my ex Royal mail van it has IGN and STAR the ACC position does nothing.
Hope I have not bored you and thanks in advance.
Replies:
Posted By: jayuk
Date Posted: August 28, 2012 at 5:02 PM
Sorry forgot to mention the vehicle specs
Iveco Daily
2.3 Unijet turbo
XLWB Right hand drive
Ex royal mail 2004
|