Print Page | Close Window

viper alarm lights won’t flash

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132128
Printed Date: July 05, 2025 at 12:31 AM


Topic: viper alarm lights won’t flash

Posted By: 20silverado06
Subject: viper alarm lights won’t flash
Date Posted: September 03, 2012 at 8:12 PM

I just got my alarm/remote start installed and working. It's the 5704 and xpresskit db-all. The parking lights work when I arm and disarm but when the alarm sets of they don't. How do I get them to. And I have it hooked up with d2d



Replies:

Posted By: auto enhancers
Date Posted: September 04, 2012 at 11:14 AM
More info please. Year make model of vehicle. How and where are the lights hooked up. Have you checked programming of the alarm.




Posted By: 20silverado06
Date Posted: September 04, 2012 at 12:02 PM
06 silverado. Nothing's wired to truck beside r/s and data wire. It's all d2d like I mentioned in first post




Posted By: 01ws6/tamu
Date Posted: September 05, 2012 at 6:24 PM
Your best bet would be to set the park lamp output to negative pulse and hard wire it at the BCM.

Tie it into connector 2 gray shell terminal B2 white wire at the BCM.
This is the park lamp relay control output from the BCM





Print Page | Close Window