Print Page | Close Window

keyless entry on 2002 durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13214
Printed Date: August 21, 2025 at 12:46 PM


Topic: keyless entry on 2002 durango

Posted By: WM2K3
Subject: keyless entry on 2002 durango
Date Posted: May 05, 2003 at 8:56 PM

I've recently installed an alarm on a 2002 Durango, but was stumped on connecting the keyless entry part.  The alarm is a autopage RS-750LCD.  I've reviewed the wiring codes for a 2000 Durango, but the information I got for the 2002 didn't match with the codes on this website.  

Also another problem is bypassing the factory alarm system because this alarm has the remote start function also. 

So basically the alarm part is installed, but not the keyless entry or the autostart.  Any help is very much appreciated.




Replies:

Posted By: draasch
Date Posted: May 05, 2003 at 9:07 PM
Power Lock WHITE/ D GREEN *** 14 PIN CONN. IN DR #217
Power Unlock SINGLE WIRE SYSTEM KICK OR CTM *

* Central Timer Module (CTM) Located In Driver Kick Panel.

*** WHITE/ D GREEN Wire Must See Ground Through 820 Ohm Resistor To Lock And Ground through 319 Ohm Resistor to Unlock.

OEM Alarm Arm L GREEN/ ORANGE (-) CENTRAL TIMER MOD LOCATED HIGH IN **
OEM Alarm Disarm SINGLE WIRE SYSTEM DRIVER KICK PANEL **


* Central Timer Module (CTM) Located In Driver Kick Panel ** Use 644 Ohm Resistor To Arm/Lock, Use 1.5k Ohm Resister To Disarm.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Print Page | Close Window