cs cm6000 negative out
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132159
Printed Date: May 09, 2024 at 9:24 AM
Topic: cs cm6000 negative out
Posted By: clueless111
Subject: cs cm6000 negative out
Date Posted: September 09, 2012 at 12:27 AM
Any suggestions how to get a negative output wire that is triggered BOTH by 1) remote start and 2) manual start (crank/key in ACC position)? Thanks.
Replies:
Posted By: howie ll
Date Posted: September 09, 2012 at 2:19 AM
The remote start has its own, status or GWR, use a latching relay from the ACC position to answer question 2.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: clueless111
Date Posted: September 09, 2012 at 4:27 AM
would i need to diode either/both the relay or the status out before I join the two?
Posted By: howie ll
Date Posted: September 09, 2012 at 11:19 AM
Yes "Y" shape going towards upright of the "Y", diode on each arm, diode bands away from upright.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|