Remote Kill Switch

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132208
Printed Date: May 15, 2025 at 11:24 AM

Topic: Remote Kill Switch

Posted By: jash12
Subject: Remote Kill Switch
Date Posted: September 17, 2012 at 4:52 PM

'98 EZGO TXT Gas

I'm looking for and how to install (pretty sure directions will be included) a remote kill switch for my EZGO. Since all keys are pretty much the same, it's pretty easy for your cart to get jacked. With no license plate, makes it pretty easy to sell online as well.

Any suggestions on a system would be great. Not sure if there are any vendors on this forum as this is only my second post.

Thank you

Jash12

Replies:

Posted By: 01ws6/tamu
Date Posted: September 18, 2012 at 11:39 PM

Cut the wire behind the ignition switch and wire a hidden toggle switch in series and pretty much it. Use a DMM to verify a wire that is hot KOER and cut it.

Posted By: jash12
Date Posted: September 22, 2012 at 12:08 PM

I'm looking for a wireless with remote.

Posted By: 01ws6/tamu
Date Posted: September 22, 2012 at 6:48 PM

Put an alarm and put on it or a keyless entry unit with a armed output on it tied to a starter disable relay.

Posted By: jash12
Date Posted: September 25, 2012 at 10:54 PM

Thank you for the quick response.

Will this system work? It has a starter kill output. What do I need to add to this system to enable the kill system to work?

1-Way Alarm and Keyless Entry System , a single stage, a starter kill output, valet switch

Thank you in advance

Posted By: howie ll
Date Posted: September 26, 2012 at 1:02 AM

A relay and a diode.
Look at this generic diagram.
83E_cut.bmp

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: jash12
Date Posted: September 26, 2012 at 8:40 PM

That's great.

Thank you

Posted By: awdeclipse
Date Posted: September 27, 2012 at 7:17 AM

If you just want a wireless starter kill, you could consider something like this.
1ch Wireless Remote Control

It is more or less a "wireless relay" how it gets implemented.

Posted By: jash12
Date Posted: October 21, 2012 at 3:44 PM

Was looking for a little bit of help here with remote kill. I've ran all my wires but I've run into a spot I need some help understanding which wire to cut and splice my relay into. All diagrams say either Ignition switch to starter motor, Ignition switch to starter solenoid, or starter wire. This is what I have.

Blue wire - Key switch > micro switch (in Pedal Box) > Solenoid D

Red wire - Key switch > +12v Fuse > Solenoid A

Black 6gauge - Starter > Solenoid B

Green wire - Starter > Voltage regulator

Thanks in advance