08 chevy malibu ignition switch

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132218
Printed Date: May 16, 2025 at 12:07 PM

Topic: 08 chevy malibu ignition switch

Posted By: ziggyb222
Subject: 08 chevy malibu ignition switch
Date Posted: September 19, 2012 at 2:42 PM

Installed a remote start in this car. Viper 4103 and uncut key in a box for bypass... One issue I had is placing the loop for the transponder bypass. I placed the ring around the outside of the switch but it has made fitting the trim cap tight. There is very little room there. Any ideas where to place the loop? A thinner loop? Or take out the switch and put it on the backside???? Any ideas would be great. Thanks in advance!!!!!

Replies:

Posted By: ropuma
Date Posted: September 19, 2012 at 8:26 PM

If the ring has a housing hard plastic cut it out , then use electric tape.

Posted By: Mike M2
Date Posted: September 20, 2012 at 11:19 AM

What i do is remove the plastic around the ring and twist the coil wires with my finger to hold them together....

-------------
Mike M2
Tech Manager
CS Dealer Services

Print Page | Close Window