positive keysense from accessory
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132300
Printed Date: May 04, 2025 at 4:21 AM
Topic: positive keysense from accessory
Posted By: rjkboyle
Subject: positive keysense from accessory
Date Posted: October 02, 2012 at 10:28 PM
Need a positive keysense wire to prevent factory alarm from going off on remote start. Can I just run a diode, stripe to keysense, off the remote starter accesory wire.
In theory I don't see why this wouldn't work.
If not, what's the best way to do this from a 5701.
Thanks in advanced.
Replies:
Posted By: auto enhancers
Date Posted: October 02, 2012 at 11:23 PM
Use a relay and gwr.
Posted By: howie ll
Date Posted: October 03, 2012 at 3:07 PM
It won't work because the ACC doesn't "go live" until after the R/Start enables.
Ignition, wait 2-3 seconds, starter, run, ACC is the order.
And the first answer is correct but diode separate the GWR before the relay, bands to R/S.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: rjkboyle
Date Posted: October 03, 2012 at 3:51 PM
Ah makes sense. Thanks for elaborating, will make sure and diode isolate. Thanks
|