Starter kill switch for 2001 Durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13245
Printed Date: May 28, 2024 at 3:42 PM

Topic: Starter kill switch for 2001 Durango

Posted By: DDrvr
Subject: Starter kill switch for 2001 Durango
Date Posted: May 06, 2003 at 4:15 PM

Greetings all!
I searched the archives for an answer to my question. Unfortunately I was unsuccessful. Hopefully someone here can help me out.
I would like to put a hidden switch in my truck, a 2001 Dodge Durango SLT, (with the 4.7L eng. and PT4WD) which when activated will allow the engine to crank, but not turn over, thereby disabling the starter.
I have seen battery kill switches that disable the battery, but if I install one of these, won't I have to reset my radio stations and clock every time I start the truck? posted_image

I would appreciate it, if someone here could advise me of the correct way to go about installing this switch. What size switch should I use, what guage wire, and would I install a relay between the kill switch and the starter, or should I go thru the ignition switch instead?
Thank you in advance for any and all help!
Tom

Replies:

Posted By: DDrvr
Date Posted: May 06, 2003 at 4:19 PM

BTW, regarding my question above, there are no other alarms currently installed in my truck. Don't know how important that may be to know, but I figured I'd better mention that!
Thanks again!
Tom

Posted By: securinu
Date Posted: May 06, 2003 at 8:08 PM

I have an 2002 durango R/T and it comes with the sentry key you can add it from the dealer that way you wont have to carry anything . or flip a switch.

-------------
Joe O'Byrne
Owner / Installer

Posted By: Chris Luongo
Date Posted: May 06, 2003 at 8:13 PM

The plastic panel in front of your knees will come down with three screws. The wiring going up to the steering column is easily seen, and the starter wire is yellow.

If you use a heavy switch, you won't need a relay. Simply cut the yellow wire in half and connect both ends to the switch. If you have to extend the wires, use wire that's just as thick as the yellow one.

If you want to use a smaller switch for whatever reason, you can just use the switch to activate a relay. There are many ways to set up the relay, but one important consideration is that you mustn't set it up so that the relay can stay on all night, or the battery will go dead.