2001 hyundai elantra manula trans
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132480
Printed Date: May 09, 2025 at 11:44 PM
Topic: 2001 hyundai elantra manula trans
Posted By: kaira408
Subject: 2001 hyundai elantra manula trans
Date Posted: October 25, 2012 at 12:49 PM
novice here, trying to install a remote starter in my 2001 hyundai elantra,the unit programs but it will not start, it gives 5 flashes and stops what am i doing wrong
-------------
lovebird
Replies:
Posted By: chev104275
Date Posted: October 25, 2012 at 1:24 PM
What system are you installing ? The flashes indicate a code which should be covered in the install guide
-------------
If i Can't Install it I Don't need it Joe
Posted By: kaira408
Date Posted: October 25, 2012 at 2:54 PM
i'm using prostart ct3471tw, there is a 5 flash code, 5 fast, the one I got is like counting
-------------
lovebird
Posted By: shortcircuit161
Date Posted: October 25, 2012 at 3:26 PM
According to the Install Manual,
5 Fast Flashes is
New Transmitter learn
Tach learn
Are other functions working? lock/unlock/trunk?
Relearn the tach and make sure you put the system into ready mode and try it again.
Also, to rule out transmitter issues, try triggering the remote starter with the purple external trigger input wire (pin 9 of the 12-pin harness).
-------------
Posted By: kreg357
Date Posted: October 25, 2012 at 3:28 PM
Here is a link to the CT-3471TW install guide : https://www.engines911.com/asdocs/CT_3471TW_ig_en_h48s40_081014.pdf
Here is the Error Code from Page 25 :
5 Fast New Transmitter learnt
Tach learnt
( Think "learnt" is Canadian for Learned  ) ------------- Soldering is fun!
Posted By: kaira408
Date Posted: October 26, 2012 at 12:38 PM
all other functions work,lock, unlock, valet, the 5 flashes I get is like 1/1000,2/1000 and so on. I also tried to put the system in ready mode but it will not go in
-------------
lovebird
Posted By: kaira408
Date Posted: October 26, 2012 at 12:54 PM
how do I trigger the remote starter with the external trigger
-------------
lovebird
Posted By: kaira408
Date Posted: October 30, 2012 at 1:41 PM
great job frank, it was the tach learning step that was needed to be done.
-------------
lovebird
Posted By: kaira408
Date Posted: October 30, 2012 at 1:53 PM
One last question, which is the best wire to use with the horn (lock, unlock, arm, disarm,or one of the aux out wires)
-------------
lovebird
Posted By: shortcircuit161
Date Posted: October 30, 2012 at 2:03 PM
Looking thru the manual that kreg357 linked to above -
Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the LOCK button is pressed, or when the LOCK
button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is enabled. If
horn confirmation is disabled, panic mode will not be available.
Mode 3
FUNCTION 2 – AUX 1 Programming
OPTION 1 Horn confirmation upon the 2nd press of the LOCK button
OPTION 2* Priority door access
OPTION 3 Horn confirmation upon the 1st press of the LOCK button
You would use either Option 1 or 3 depending on your personal preference.
-------------
Posted By: kaira408
Date Posted: October 30, 2012 at 2:30 PM
you keep doing what you do because you are good thanks
-------------
lovebird
|