programming second remote for bullydog ke

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132561
Printed Date: June 01, 2024 at 7:03 AM

Topic: programming second remote for bullydog ke

Posted By: hodder
Subject: programming second remote for bullydog ke
Date Posted: November 03, 2012 at 12:20 PM

I am having problems programming the second remote for a bully dog KE1702 I followed the instructions in guide but I can not get it to work.

any help would be great.

Ralph

Replies:

Posted By: kreg357
Date Posted: November 03, 2012 at 2:46 PM

Sometimes it's easier to un-plug the control unit, wait a few minutes , plug it back in and start fresh.

-------------
Soldering is fun!

Posted By: hodder
Date Posted: November 03, 2012 at 3:32 PM

i have try that several times it and still know luck

Posted By: kreg357
Date Posted: November 03, 2012 at 3:51 PM

It is only allowing you to have one remote on the system?

Have you tried the second remote first after a reset? ( Just to make sure it works OK. )

-------------
Soldering is fun!

Posted By: hodder
Date Posted: November 03, 2012 at 5:20 PM

yes also try that i must be doing something wrong when i try to prorgam remote.

Posted By: kreg357
Date Posted: November 03, 2012 at 5:43 PM

Well, if either remote will work by itself and you can't add a second...

It's either a procedural problem or a bad brain. The programming is pretty basic. Just press and hold the LOCK button on the working remote for 10 seconds, then
press and hold the LOCK button on the second remote for 5 seconds. Not sure if there is a time restriction / limit.

Bulldog Security has a good Tech Support group. Might try them on Monday. 1-800-878-8007

-------------
Soldering is fun!

Posted By: hodder
Date Posted: November 03, 2012 at 8:27 PM

so i do not have to put it in program mode ?

Posted By: kreg357
Date Posted: November 03, 2012 at 9:46 PM

Don't think so, but I'm not positive. Haven't installed a Bulldog unit in many years. I remember doing a few RS1100's and as soon as they had power applied ( or a memory clear ) you just pressed the LOCK button on each of the remotes and that was it. Have you tried it without going into Program Mode first?

-------------
Soldering is fun!

Posted By: hodder
Date Posted: November 04, 2012 at 5:40 AM

i will try that that this morning that is probaly what i am doing wrong. i will let you know

Posted By: hodder
Date Posted: November 04, 2012 at 7:02 AM

yeh got the remote number to to work it was a matter of timing in the program button

thanks for help