viper manual

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132648
Printed Date: April 29, 2024 at 3:50 AM

Topic: viper manual

Posted By: namyenruoj
Subject: viper manual
Date Posted: November 12, 2012 at 3:15 AM

bought a used car recently with viper car alarm installed already. didn't come with installation manual at all. i phoned the tech support. they want me to find out what model car alarm do i have by looking at the control under the dash.so i did find where the control is but there is no model number written anywhere. this is the wiring diagram i found on the control

orange (-) output when armed
white (-) output parking lights
wh/bl (-) 2 volt output led
bk/wh (-) input valet/program button
green (-) input door switch Z3
blue (-) input instant trigger
violet (+) input door switch Z3
black (-) input chasis ground
yellow (+) input switch ignition
brown (+) output siren
red (+) input 12 volt power
RED / wh (-) input channel 2

these numbers i also found on the control panel
DES 345.711
HWAZC00B
OK/1D
MADE IN TAIWAN
1-800-361-7271

viper remote control RPN 491

made by DEI
i am looking for installation manual so i can program this alarm. thank you

-------------

Replies:

Posted By: smokeman1
Date Posted: November 12, 2012 at 6:22 AM

Maybe this site can help you narrow it down: https://www.drdetailshop.com/DEI-HF-Remote-Replacement-Selection.htm

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: lurch228
Date Posted: November 14, 2012 at 12:53 AM

Also check the Circuit Board # on the remote to help limit the possible choices that have that Date Code of OK/1D. If the led on the remote is green then the case was changed and it's probally a 471 remote as no cross is listed for a 491 remote with a brain date code to match what you listed. Then use the FCC ID Chart at the bottom of this link:drdetailshop verify the remote number. I assume the remote is currently working with the alarm, if not then it's probally the wrong remote.