Ok i have done several hours of reading and am now going to tackle this project I thing i have all basics covered i will be doing the d2d setup
6 pin harness
h1 is this the red white or can i use any constant 12v source
h2 ground H3 brown horn 24 pin tan/pink bcm H4white lt blue grey bcm
door lock 3 pin d2d
8 pin
h1+ ign 1 out pink to pink ignition wire
h2 + 12v constant input red white to red white ign wire
h3 + acc. output orange to orange at ign
h4 violet not used h5 red not used
h6 ign 2 flex output pink white to brown at ign?
H7 ???? flex relay output87a if req i dont think i need
h8 + 12v constant input for acc and start red black to red white (seems like a lot of wires running to redwhite ign wire
dball
in the 12 pin it says to conect the black white RAP off What is that???
What is bulb test passlock 1 only mean?
The rest i think i have other then the door - to positive thing but do i even have to hook these up on the remote start or dball side? I had my wifes last car done professionally and you could not open doors with remote start fob and and had eto shut off car using remote start remote and then unlocking doors with car factory fob or just use the key to get in so my wifeis used to this anyway
Thanks for any input good or bad i did a few of these years ago in some chrysler but no the theft or bypass stuff needed then Thanks I do have the loader to flash dball befor install as well
This is for a 2005 chev equinox lt soory thanks
You won't need the Bulb Test wire on this vehicle. RAP is Retain Accessory Power.
Link to the info provided to me: https://www.the12volt.com/installbay/forum_posts.asp~TID~132274~KW~smokeman1~PN~1~TPN~1
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Ok i think i have r/s wired up but now onto the dball the violet/green and violet/brown wires are conected together at (they say yellow at ing switch but none there) I did find the wires they say in the 16 pin grey connector at bcm. So this is where i connect the two dball wires? Also do i need to do anything with the doors? I will do them later running out of time today. I also am unsure of where black white RAP off wire goes coming from dball Thanks
i think i found the rap wire grey black at pink connector in bcm
The Yellow wire at the ignition switch is going to be a small gauge wire at the ignition switch. It is not in with the Accessory, 12 volts, Ignition. Should be on a small three pin connector.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation