directed 528t issues
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132876
Printed Date: May 02, 2025 at 2:13 PM
Topic: directed 528t issues
Posted By: draggin95niss
Subject: directed 528t issues
Date Posted: December 03, 2012 at 7:22 PM
im using a dei 528t to trigger relays to trigger the valves for my suspension to lay out the truck when the system is armed, im using the ground w/armed to trigger the 528t, ,y problem is ive burned 2 of these so far and am not so sure why they would keep burning, the 1st one lasted a couple months and burned a resistor on the board, (box is clear) and the 2nd one i just installed tonight and tested it 5-6 times and it also burned in the same spot, im drawing a blank here seeing as im using it to trigger relays, also i have a 530t window module that is using the ground w/armed to trigger the roll up but they are both diode isolated from eachother,any info is appreciated, thanx in advance....
Replies:
Posted By: draggin95niss
Date Posted: December 03, 2012 at 7:30 PM
also to add it burned both times when remotestarted if that might explain anything...thanx..
|