Print Page | Close Window

2009 lancer, prostart ct-3271

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132940
Printed Date: October 31, 2024 at 5:56 PM


Topic: 2009 lancer, prostart ct-3271

Posted By: diamond_4g64
Subject: 2009 lancer, prostart ct-3271
Date Posted: December 10, 2012 at 2:43 PM

Hi, i have a couple of questions on this install.x this is a first so i am hesitant on some wires. I have the lancer ralliart 2009 and my remote starter is the ct-3271 from prostart.

I would like to know for the parking lights. I have the brown and wellow wire in my car exactly the same as the pic above.
On my remote starter i have a 5 wire plug with onethat is a parking light (+)
I have anothr 3 wire plug with one that is written parking light output (-)

Do i use both and what do i connect where? It seems t says it does not matter. In the manual it just says connect one with one of the wires and the other with the other wire... is this ok?

-------------
Wake up and drive...or... flat over crest!



Replies:

Posted By: smokeman1
Date Posted: December 10, 2012 at 8:17 PM

Grab a Digital Milti Meter, then go to the downloads section of this site. Download the Viper 5701 Install Manual. Ther is a section in it on how to test for the wires you need.

Link to Bulldog Security Wire Guide:  https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp

Wire Guides are GUIDES, Your car may have different wire colors. So TEST and VERIFY the wires you are using.

Do a search on this site for your year, make and model of car for any information.



-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation





Print Page | Close Window