Print Page | Close Window

remote start a c 2007 murano

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133022
Printed Date: May 04, 2024 at 7:30 PM


Topic: remote start a c 2007 murano

Posted By: sucks37123
Subject: remote start a c 2007 murano
Date Posted: December 18, 2012 at 8:34 PM

I have a 2007 Nissan Murano S with a viper 771xv viper remote start with the flashlogic flcan.

When ever I remote start the car it puts the air on the floor turns on the A C on and sets temp to 75. I cut the accessory wire thinking that would take care of the problem but it did not help.  By default the Murano defrost automatically turns on the A C. Any way to just make it use the setting i left it on?????




Replies:

Posted By: pomerlo
Date Posted: December 19, 2012 at 2:46 PM
First tought.... My 2007 Murano SL retain the settings between remote starts. The Murano has 2 accessory wire...

Search this forum.... it has the wire color for the second acessory. Feed it with the Viper 2nd acc or a relay if the viper doesn't have a 2nd accessory output.





Posted By: offroadzj
Date Posted: December 19, 2012 at 2:48 PM
Ready remote shows 2 accessory wires:
Accessory      red      +      ignition switch, white 6 pin plug, pin 4     
Second Accessory      WHITE/ blue      +      ignition switch, white 6 pin plug, pin 2

Connect the 2nd accessory as listed above and see if the problem persists. Did you also connect the 2nd starter?

-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205




Posted By: uros
Date Posted: January 23, 2014 at 3:40 AM
Hi,

Can you tell me how did you install conecct flcan to alarm in yours Murano

I have Python and Flcan, to install.
Are there any tricks or something special i need to know?

Thank you




Posted By: triniforever
Date Posted: January 23, 2014 at 7:34 AM
I believe when you are flashing the module there is an advanced setting where you can actually set the temperature control of the vehicle

-------------
triniforever





Print Page | Close Window