viper 5904 dball 03 silverado

Dball wiring diagram requires Ground While Running connection to viper 5904 but there is no GWA point shown on 5904 wiring diagram.
And do the 5904 H3/2 + fused ignition 2 input, the H3/6 + fused ignition 1 input, and the H3/9 + fused accessory/starter inputs connect to the vehicle ignition red wire?

The Viper GWR is a DARK BLUE wire marked as (-) 200mA STATUS OUTPUT.  The ORANGE (-) 500mA GR0UND WHEN ARMED 0UTPUT
may not be necessary for your install.

Yes, all three H3 +12V constant input wires ( plus the H1/1 Red wire ) go to the trucks +12V constant wires.  There should be two going to
the ignition switch, one Red and one RED / White.  You should split the Vipers wires between both of these supply wires.  Here is a link to
a pictorial on a 2003 Yukon, which should be pretty much the same as your Silverado  :  https://www.the12volt.com/installbay/forum_posts.asp~TID~133000~PN~1

-------------
Soldering is fun!