2008 infiniti pts m35
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133172
Printed Date: May 14, 2025 at 7:42 PM
Topic: 2008 infiniti pts m35
Posted By: triniforever
Subject: 2008 infiniti pts m35
Date Posted: January 03, 2013 at 3:11 PM
Hey guys ,I need some help ,I recently installed a Viper remote start and keyless entry with an Idatalink module flashed with the latest firmware on this vehicle ,everything works fine except the takeover part, whenever the car is remote started and the doors or should I say the driver door is unlocked with the factory or aftermarket remote and when the vehicle is entered and the door is closed the remote start shuts down in like two seconds,so key takeover does not happen and I can't figure out why. Maybe I am missing something any help is appreciated .................thanks..........Triniforever
-------------
triniforever
Replies:
Posted By: Twelvoltz
Date Posted: January 06, 2013 at 8:34 AM
Did you connect the GREEN/ red from the ADS module to ground? This would cause the problem you're describing.
-------------
Installer, IT support, and FFL. I need less hobbies.
|