clifford matrix with 507m tilt sensor
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133307
Printed Date: April 29, 2024 at 1:49 AM
Topic: clifford matrix with 507m tilt sensor
Posted By: tonynca
Subject: clifford matrix with 507m tilt sensor
Date Posted: January 15, 2013 at 2:23 AM
So I hooked up the tilt sensor to all the wires that the instruction manual indicated since the harness did not work with my 4-pin sensor input on my alarm.
Ground when armed to orange wire
Instant trigger to blue wire
12v constant to the red wire
I didn't use any diodes, I'm not sure if I should or not. Seems to work fine for now. One problem I'm having is that since my ground when armed wire is for the trunk pin, I get a trunk tamper indicator when the tilt sensor is triggered. Does anyone know how to get the 507M sensor to trigger the tilt sensor indicator on the LCD remote?
I heard that I may have to buy the Bitwriter to program the sensor to my alarm. Could someone confirm?
Replies:
Posted By: tonynca
Date Posted: February 02, 2013 at 1:32 AM
FYI for people with the same issue as me. I found a solution with the help of some folks on my.is: https://my.is/forums/f103/directed-507m-tilt-sensor-clifford-matrix-12-5x-448318/
The sensor now worked perfectly after using a Bitwriter to program Zone 4 and swapping the red and blue wire so it correctly matches the pin-out on the alarm's sensor port.
|