10 mkx no heat on remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133377
Printed Date: May 22, 2024 at 7:56 PM
Topic: 10 mkx no heat on remote start
Posted By: __tt__
Subject: 10 mkx no heat on remote start
Date Posted: January 21, 2013 at 1:04 PM
has anyone seen a no heater blower situation on a 2010 MKX.
And yes I've checked all wiring IE: white orange for ign, and purple green for acc.
symptoms are this
car starts and everything lights up just no blower
If I insert key and turn to ign and leave RS ON it still doesnt blow
Once I hit brake the blower comes on
Its the same in Takeover
Once the RS takes over blower goes dead
Not using a dball just an RFLOOP
Replies:
Posted By: kreg357
Date Posted: January 21, 2013 at 4:00 PM
Did you use a DMM to verify that the R/S is outputting +12V on the PURPLE / Green ACC wire?
-------------
Soldering is fun!
Posted By: soundnsecurity
Date Posted: January 21, 2013 at 6:10 PM
never done an MKX before but if you know for sure that every wire you have hooked up is getting power when it should be i would start looking at any other wires you see at the ignition harness that isnt being powered by the remote starter, maybe there is a wire that is not mentioned by whatever tech sheet you are using. ive had this happen to me plenty of times.
-------------
Posted By: hagar
Date Posted: January 21, 2013 at 11:22 PM
If the starter anti-grind cut off was placed in the accessory wire instead of the starter wire this would cause the blower fan to not power up until after the brake light is activated.
|