pkall programmed again despite manual
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133383
Printed Date: May 14, 2025 at 1:32 PM
Topic: pkall programmed again despite manual
Posted By: dpav02
Subject: pkall programmed again despite manual
Date Posted: January 21, 2013 at 9:57 PM
Okay so something strange happened to me today.
I was doing other work to my 4Runner and I disconnected the battery.
Once I got finished I connected the battery.
Then I tried to show off my remote start and my truck just cranked and cranked... I shut it down because I didn't want the starter to burn up...
I tried it again with the key in and it worked. I had a feeling it was the bypass so I checked the connections (they all look good)
Even though the manual says that they can't be programmed again, I figured I'd try it for the hell of it.
Sure enough, I got 10 blinks on the LED... I'm thinking, wth...
Is this common? This PKALL was programmed and working fine until I disconnected the battery. Did that cause it to lose it's mind?!?!
Replies:
Posted By: pentavolvo
Date Posted: January 22, 2013 at 6:04 PM
manual states after a battery disconnect must start with key once before remote starting
|