2008 Mazda 3 Alarm/Remote Start Wiring

Can anyone give the wiring diagram or information for 2008 Mazda 3.
I would like to install a 2 way security w/ remote start.

Thanks,
Ncreglos

-------------
**O**
^^^^^^

DIRECTWIRE™ WIRING INFORMATION - MAZDA / MAZDA3 / 2008 / Remote Start

[PRINT THIS PAGE]

12volts      BLACK/ red (30A)      +      ignition switch
Notes: If equipped, the Sirius Satellite Radio is under the top center of the dash.
Starter      gray/black      +      ignition switch
Second Starter      N/A           
Ignition      GREEN/ YELLOW      +      ignition switch
Second Ignition      N/A           
Third Ignition      N/A           
Accessory      pink / YELLOW      +      ignition switch
Second Accessory      yellow      +      ignition switch
Keysense      RED / black      +      ignition key switch
Power Lock      GREEN/ red to BLACK/ blue      -1000 ohms      driver kick or PJB, brown 32 pin plug (J-06), pin T
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Power Unlock      same as power lock      -     
Lock Motor      yellow/black      5 wire      driver kick or PJB, 46 pin plug (J-05), pin AP
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Unlock Motor      WHITE/ black      5 wire      driver kick or PJB, 46 pin plug (J-05), pin L
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Parking Lights+      ORANGE / white (L), orange (R)      +      passenger kick or PJB, 46 pin plug (J-05), pins G and AS
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Parking Lights-      BLACK/ white      -      light switch or PJB, 46 pin plug (J-03), pin I
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Hazards      BLACK/ orange      -      hazard switch or PJB, blue 32 pin plug (J-04), pin AC
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Turn Signal(L)      blue      +      passenger kick or PJB, 46 pin plug (J-05), pin A
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Turn Signal(R)      blue/red      +      passenger kick or PJB, 46 pin plug (J-05), pin AK
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Reverse Light      GREEN/ orange (4 door), GREEN/ black (5 door)      +      passenger kick or PJB, 46 pin plug (J-05), pin C
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Door Trigger      BLACK / YELLOW      - N.C.      driver kick or PJB, brown 32 pin plug (J-06), pin W
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Dome Supervision      BLACK/ blue      -      passenger kick or PJB, 46 pin plug (J-05), pin U
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Trunk/Hatch Pin      BLACK/ red      -      pass kick or PJB, brn 32 pin plug (J-06), pin Z (4 door) or X (5 door)
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Hood Pin      BLACK / YELLOW      - N.C.      hood switch or PJB, green 32 pin plug (J-02), pin Y
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Trunk/Hatch Release      N/A           
Power Sliding Door      N/A           
Factory Alarm Arm      BLACK/ blue      -      driver kick or PJB, brown 32 pin plug (J-06), pin Y
Notes: The PJB (Passenger Junction Box) is behind the glove box.

Meter this wire while turning the key in the driver door key cylinder.
Factory Alarm Disarm      BLACK/ white      -      driver kick or PJB, brown 32 pin plug (J-06), pin AA
Notes: The PJB (Passenger Junction Box) is behind the glove box.

Meter this wire while turning the key in the driver door key cylinder.
Disarm No Unlock      use keysense           
Tachometer      BLACK/ stripe (non-turbo) or GREEN/ stripe (turbo)      ac      any fuel injector
Wait to start      N/A           
Brake Wire      RED / white to RED / yellow      +      brake switch, driver kick, or PJB, 46 pin plug (J-05), pin M
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Parking Brake      BLACK/ lt. green      -      parking brake switch or PJB, blue 32 pin plug (J-04), pin AB
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Horn Trigger      black      -      horn switch or PJB, blue 32 pin plug (J-04), pin N
Notes: The PJB (Passenger Junction Box) is behind the glove box.
Memory Seat 1      N/A           
Memory Seat 2      N/A           
Memory Seat 3      N/A           

Interface Modules: Not Available


      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.


What remote start / alarm unit and bypass are you using?

-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205

Thanks Kenny, this will help me a lot.

-------------
**O**
^^^^^^

I have a Power Teknique 2 way security system w/ remote and a PKFM platform 4 bypass module. Do you think this will work? Do you have a wiring diagram for installing bypass module. My alarm doesn't have a D2D connection, I guest I will go with W2W, But don't know how to do it.

Thank,

-------------
**O**
^^^^^^

I don't have anything for that bypass, but you should be able to find it available either online or from the manufacturer if it did not come with it. I have never installed the Power Teknique so I have no idea about any of those connections etiher.

I prefer to stick with Compustar and iDatalink for all my remote start parts.

-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205