Installing a Viper 5704 on a 2001 F150 and I can't get the Flcan module to program and I can't get the control to work to get the system to change from manual to automatic. Anybody have any ideas.
Probably dumb questions, but I don't want to assume things or overlook anything.
Is the FLCAN flashed with the FLC-AL(TB)-FM2 firmware? There are many different firmwares available for the FLCAN but only FM2 is correct
for your truck.
Did you set the FLCAN Installation Mode to Data ( 1 LED flash ) and lock it in prior to vehicle programming? Guessing that you are going D2D and
using the supplied D2D harness to connect to the 5704. There are only three connections that must be made ( soldered ) to the truck from the
FLCAN. The instructions are pretty good and the wire listing very accurate.
The 2001 F150 is PATS1 and should only need one key to program so you should get the Green LED at step 3.
As for the Viper 5704 programming, do a search on that very topic. It has been discussed many times in the past. There are some important
Viper connections that must be made and working properly prior to entering into programming mode and it takes some time, trail and error,
and effort to get the hang of it. Keep trying...
-------------
Soldering is fun!
Thanks for responding. I got it all working Sunday evening but I do have one question. Does the WHITE/ pink heavy gauge wire power the climate control. My heater control and fan doesn't work with the remote start. It starts working when I put the key in.
Bulldog Security shows two ACC for that truck. ACC 1 Gray / YELLOW (+), and ACC 2 BLACK/ Light Green (+). Test WIth DMM
https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp
Pink/White is defaulted as Ignition 2 from the factory and needs to be changed to ACC 2, in Menu 3, Item 8, Option 2.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Yes. Actually your ignition wiring should look something like this :
Viper 2001 F150
1 PINK (+) IGNITION 1 INPUT/OUTPUT Dark Blue/Light Green
2 RED / WHITE (30A) FUSED Flex Input Yellow
3 ORANGE ACCESSORY OUTPUT Gray / YELLOW
4 VIOLET (+) STARTER OUTPUT (CAR SIDE) RED / Light Blue - cut wire
5 GREEN (+) STARTER INPUT (KEY SIDE) RED / Light Blue - cut wire
6 RED (+) FUSED (30A) IGNITION 1 INPUT Light GREEN/ Purple
7 PINK/WHITE (+) FLEX RELAY OUTPUT RED / Black
8 PINK/BLACK FLEX RELAY INPUT 87A Not Used
9 RED / BLACK FUSED (30A) ACC/STARTER INPUT Light GREEN/ Purple
10 N/C N/C
Extra 30/40 Amp SPDT Relay
Pin 85 to Viper Orange (-) 200mA Accessory Output
Pin 86 and 87 to F150 thick Yellow +12V constant @ ignition switch harness, fused at 30 Amps
Pin 30 to F150 BLACK/ Light Green @ ignition switch harness
Pin 87a not used - insulate
-------------
Soldering is fun!
The pink/white is not hooked up so that would probably explain the heater not working. I will hook it up this weekend. This is my first alarm and remote start install but everything works except the heater control
Thanks a ton kreg357. The wiring diagram you sent me worked perfectly. Everything works as it should now. I would have never known to change the setting from ignition to accessory. This website ROCKS!!!!!!!!!!!!