compustar drone mobile not communicating
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133700
Printed Date: June 19, 2025 at 7:46 PM
Topic: compustar drone mobile not communicating
Posted By: mwhidden
Subject: compustar drone mobile not communicating
Date Posted: February 25, 2013 at 10:17 PM
Has anyone else had problems hooking up a DR-2000 to a Compustart Controller?
I'm using the new DR-2000 hooked to a new CM-6000 Alarm/Starter using the RS232 port.
The DR-2000 shows everything is active but it seems to fail to communicate with the Brain.. It seems to receive commands but nothing happens.
-------------
Bush League
Replies:
Posted By: offroadzj
Date Posted: February 26, 2013 at 6:03 AM
Check continuity between all of the pins in the data harness and make sure none of the pins are loose. Just for an example, I've had a couple remote starters that worked great, but the range was nowhere near what it should be. After a quick look, the antenna wire had ever so slightly pulled from the unit. After plugging it back in tight the range was great.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: lucasoil4u
Date Posted: February 26, 2013 at 9:59 AM
Power cycle the unit then remote start the car once with the remote to let it comminunicate with the drone module.
Posted By: metz35
Date Posted: February 26, 2013 at 2:39 PM
If your car requires a bypass.
You MUST use a blade AL
A blade TB does not work at all with a drone.
|