Print Page | Close Window

Help, Viper C-60 alarm hook up

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13381
Printed Date: August 12, 2025 at 10:38 PM


Topic: Help, Viper C-60 alarm hook up

Posted By: kevmor99
Subject: Help, Viper C-60 alarm hook up
Date Posted: May 10, 2003 at 2:52 PM

I just got a used viper c-60 alarm and I wanted to test it before installing it.  I hooked up ground to the constant ground and 12v to constant power.  As soon as I do this, the siren wire gets power and I can hear a relay click on and off (I assume the parking lights flashing).  The wire for ground when armed doesn't have ground at any time.  When I use different buttons on the two remotes I have neither effect it.  After about 20-30 seconds the alarm cycles off and I can make it go off again by putting ground to one of the sensor wires.  I tried the valet switch but it didn't seem to change anything.  If this alarm was out of a vehicle for a while, would it have lost it's memory for the remotes to work and do I have to reprogram them?  Putting power to the ignition on wire only makes a relay come on/off and doesn't turn off the alarm either.  Am I doing something wrong? It just doesn't seem to be working quite right.  It was fine when taken out of the vehicle.



Replies:

Posted By: draasch
Date Posted: May 10, 2003 at 7:41 PM
you can try dei.com and see if u can find the wiring info for that alarm

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Posted By: jaxman
Date Posted: May 13, 2003 at 3:24 PM
Must be an old system as I never heard about a Viper C-60.
If the system was out for 10 years if the reotes were from that system they should still work.


Print Page | Close Window