viper 5706p auto trans program :

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133921
Printed Date: May 13, 2025 at 3:56 AM

Topic: viper 5706p auto trans program :

Posted By: randyhub
Subject: viper 5706p auto trans program :
Date Posted: March 24, 2013 at 6:26 PM

Well worked until 4:30 am Saturday night pullng out all the wiring of the Carvox remote starter/alarm all went well for the most part.

All connections are soldered and shrink wrapped and everything works well for the alarm except the remote starter? It keeps showing an error on the 2way remote flashes 7 times, the manual says it is in manual transmission mode? Seems they default to manual transmission still trying to find out how to program it for auto transmisson and as well set the time on the 2way remote display?

Anyone know how to fix this?

Thanks

Randy

Replies:

Posted By: smokeman1
Date Posted: March 24, 2013 at 7:56 PM

Open car door, Turn ignition on, then off. Press AND hold button on antenna until you hear three chirps from the siren, release the button, then press the button ONCE and release, then Press and HOLD. Should get one chirp and one flash from the LED. Press the lock button on the remote, should get two chirps. Release the button, Turn the ignition on then off. Should be in automatic mode.

Don't forget to do TACH learning.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: randyhub
Date Posted: March 24, 2013 at 8:01 PM

Thanks will try that again, one thing I did hook up the tach wire to protect against over reving may I trouble you for the tach learning sequence please?

Thanks again

Randy

Posted By: smokeman1
Date Posted: March 24, 2013 at 8:21 PM

Start vehicle with key. Within 5 seconds press and hold the button on the antenna. TACH signal is learned when LED light is constant. Release button, turn off vehicle. This info should be in the install manual.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: randyhub
Date Posted: March 24, 2013 at 8:27 PM

Thank you, reading the manual now.