clifford inteliguard 950 wiring
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133969
Printed Date: October 31, 2025 at 7:30 AM
Topic: clifford inteliguard 950 wiring
Posted By: longboard511
Subject: clifford inteliguard 950 wiring
Date Posted: April 01, 2013 at 12:29 PM
hiya ive got to put a inteliguard 950 into my beetle i have the alarm and all the wiring
is the concept 650 mrk 2 wiring the same? as i have the manual for this
also how do i connect a omni sensor?
Replies:
Posted By: howie ll
Date Posted: April 01, 2013 at 6:00 PM
I'Guard 950 = concept 650 Mk. II
Plug it and set the unit into test mode then drive slowly into a wall.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: longboard511
Date Posted: April 02, 2013 at 5:24 PM
ok the omni sensor has a molex type plug where as the alarm has a port on the side for the omni sensor do i need a adapter ?
Posted By: howie ll
Date Posted: April 02, 2013 at 10:28 PM
Think you've been sold a pup!
There should be a 3 terminal plug going to the Omnisensor port at one end.
The joys of Fleabay etc.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|