1999 nissan quest parking lights
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134169
Printed Date: May 19, 2024 at 12:41 PM
Topic: 1999 nissan quest parking lights
Posted By: benzo33
Subject: 1999 nissan quest parking lights
Date Posted: May 05, 2013 at 8:01 PM
Hello. I am installing an Autopage 665 remote start and need info concerning the parking lights. According to the wiring manual, I need to cut the RED / white wire from the 5 pin harness and ground it. This should change the polarity if the white parking light output so that they will flash. The negative connection is gray/red (-) on the quest. Is this correct?
-------------
2001 Corolla S and 2005 Neon SRT 4 ACR.
Replies:
Posted By: kreg357
Date Posted: May 05, 2013 at 9:31 PM
Yes. The AutoPage 665 comes pre-wired for (+) Parking Lights. Cutting the RED / White wire after its fuse and before the connection to the main +12V power input wire and then connecting the cut RED / White to chassis ground makes the Parking Light relay input chassis ground.
-------------
Soldering is fun!
Posted By: benzo33
Date Posted: May 27, 2013 at 11:25 AM
Thanks! I finally was able to work on it last Friday!
-------------
2001 Corolla S and 2005 Neon SRT 4 ACR.
|