alarm output
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134170
Printed Date: July 19, 2025 at 7:10 PM
Topic: alarm output
Posted By: recks
Subject: alarm output
Date Posted: May 06, 2013 at 2:53 AM
Hey guys I have a quick question, I was wondering if I can use my alarm output for more than one use? For example starter kill, window roll up?
Replies:
Posted By: howie ll
Date Posted: May 06, 2013 at 7:13 AM
Define alarm output.
Are you talking about NEG aux outputs?
If so then yes of course.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: i am an idiot
Date Posted: May 06, 2013 at 11:29 AM
The starter kill output of the alarm has ground on it the entire time that the alarm is armed. As long as your window control module is good with a constant ground, you will be fine. If not, you will need to try and find a diagram that will convert the constant to a pulse without flattening (For Howie) your battery.
Posted By: howie ll
Date Posted: May 06, 2013 at 11:31 AM
OK Craig, what do the colonials call it, draining?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: recks
Date Posted: May 06, 2013 at 11:33 AM
howie ll wrote:
Define alarm output.
Are you talking about NEG aux outputs?
If so then yes of course.
Yes sorry i should of added that extra detail on my arm its labeled: Armed Output(-) 500mA.
Posted By: howie ll
Date Posted: May 06, 2013 at 11:36 AM
That would be good for window closers such as the DEI 429t and 530t but not for a remote start, you would need a momentary output.
What alarm?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: recks
Date Posted: May 06, 2013 at 11:39 AM
howie ll wrote:
That would be good for window closers such as the DEI 429t and 530t but not for a remote start, you would need a momentary output.
What alarm?
No remote start i know i have to use an AUX output I'm taking about a Starter Kill.
Posted By: howie ll
Date Posted: May 06, 2013 at 11:44 AM
So use this diagram, a 1N4004 diode and a 5 pin Bosch/Tycho cube type automotive relay.
The orange wire in the diagram would be your armed output.
ZBF_cut.bmp------------- Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|
