autopage rs720
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134450
Printed Date: May 14, 2024 at 5:11 PM
Topic: autopage rs720
Posted By: cairo0203
Subject: autopage rs720
Date Posted: June 27, 2013 at 7:28 PM
Hi guys,
I’m in need of a little bit of help with my RS720 install. I have already installed the correct wire to the appropriate locations (just for the remote start so far). However, after reading the installation manual, I am a little confused on how I can go about installing my transponder that I have purchased. I have a 2000 Nissan Altima with a chipped key that is already programmed to the vehicle. Any feedback would be much appreciated. Thanks ------------- Amr
Replies:
Posted By: howie ll
Date Posted: June 28, 2013 at 6:28 AM
Is the transponder by-pass a key in the box device?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: cairo0203
Date Posted: June 28, 2013 at 7:13 AM
Correct, it is the one that I would have to put in a box. ------------- Amr
Posted By: kreg357
Date Posted: June 28, 2013 at 8:09 AM
The Brand and Model number would help as each one is slightly different. Might be a Directed 556UW or something like that.
-------------
Soldering is fun!
Posted By: cairo0203
Date Posted: June 28, 2013 at 8:57 AM
Here is what I have with the below link. I would rather be extra careful before wiring it up. I get that I need to connect it to the constant 12 volts. However, im a bit confused about connecting to a third ignition.
https://www.directedstore.com/manuals/20402.pdf ------------- Amr
Posted By: howie ll
Date Posted: June 28, 2013 at 9:43 AM
Third ignition would be a NEG ground when running, A.K.A. status output or wire.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: lucasoil4u
Date Posted: June 28, 2013 at 11:27 AM
Why use a key in box? There is so much better out there. Please explain.
Posted By: cairo0203
Date Posted: June 28, 2013 at 2:55 PM
Thats what my research kicked back at me (transponder that needs an extra key). What is out there? Currently all my car dash does is the dash would flicker and not start at all.
Posted By: benzo33
Date Posted: July 01, 2013 at 4:42 AM
There is idatalink which you could hardwire or uses D2D. Rather than leaving a key under the dash.
-------------
2001 Corolla S and 2005 Neon SRT 4 ACR.
Posted By: lucasoil4u
Date Posted: July 12, 2013 at 10:53 AM
Idatalink would be the way to go. That way you dont loose a key and if you ever need to add keys you dont have to take the key out of the box. Also the data bypasses are a lot lower current draw when sitting idle.
|