2013 honda crv with omega au 93 4

Getting ready to add an Omega AU-93-4 window module to my wife’s crv. After reading the instructions from the download section have a few questions,

1) Does anyone have a wiring diagram for the windows; I’ve been looking with no luck. I can take it apart and test it but I’d rather know what I’m doing when I start.

2) If the system is not rest at ground I will need relays and I’d like to know that before I start.

3) Does anyone see a reason why I can’t use a second module triggered by an auxiliary on my Viper 4704 to roll the windows down.

Thank You

1) Motor wires, you'll be removing the door panels anyway, 2 seconds to test!
2) I'll give you better odds on winning the lotto than your windows are anything but type "A" NEG (-) at rest.
some Mercedes, VW Polo and Euro GM were pos at rest, all US and Japanese if not comfort close will be NEG at rest.
3) Absolutely not, use a second module although the much better DEI 530t is set up ready for roll-up vent and roll-down.
You will need two x 530t for 4 windows.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Thank you, I appreciate your help, I read the directions for the 530T and have one more question. The H2/5 Gray (-) output during activation wire on the 530T, does that always have to be connected to a relay or only if the windows rolling up are setting off the alarm.

Thanks

Only if the windows set off the alarm.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Thank you.