viper 5709 sensor port

hi this is my first post,

I have install a viper 5709 with a DBALL in the D2D port, I don't like the way the "professional installers" did this, I re-tape all cables and I support right all the parts and cables, all is working fine.

but I install this, in this way

Disturbance Sensor 508D is connect in the sensor port 2

Glass Break Sensor 506T is connect in the sensor port 1 (zone 4)???? with the shock sensor coming with the alarm in (zone 2) I thing it is
the 506t manual say that.

Tilt Motion Sensor 507M I connect this in the cable H2/19 (TRUNK PIN/ INSTANT TRIGGER INPUT)

all are working. I but a bitwriter for program the zone 4 because I buy a extra 7941v lcd remote because looks very nice, and I want see the different animation when the alarm is activate, but I program this zone 4 like glass sensor but only get in the remote shock sensor activate all the time, what can be wrong??? individualy all sensor works and activate the alarm but in the remote only I see the the shock animation

other cuestion some times with the remote start I get a VEHICLE SECURITY SYSTEM alert in the dash I have a Nissan rogue 2012, some time this alert disappear when I put the key and I put in ON, them I push the break pedal for deactivate the remote start and the VEHICLE SECURITY SYSTEM light appear again in the dash, but the car works normal with this light in the panel, can be a problem in the feature what I can do?

I take my car to tree different "professional installers" but one make a horrible job over the last one that I way I did by my self

thak you.



-------------
Javier

sorry also how this sensor 1 and sensor 2 are inside the unit they are parallel connection only, it is the same if I choose port 1 or port 2???

thanks

-------------
Javier