security light, 08 chevy cobalt
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134796
Printed Date: April 26, 2024 at 8:21 PM
Topic: security light, 08 chevy cobalt
Posted By: als777on
Subject: security light, 08 chevy cobalt
Date Posted: August 28, 2013 at 9:33 AM
Hello New member here I have just purchased and installed the Viper 5904 Along with the XK09 Express kit On my 08 Chevy cobalt. Installed on this vehicle and everything is working fine except After I remote start the vehicle turn off the alarm and put the key in the ignition the factory security light on the dash will not stop flashing Until I turn the vehicle off and then start the vehicle back will only Light turn off. Any help with this problem would be much appreciated thank you
-------------
Als777on
Replies:
Posted By: lucasoil4u
Date Posted: September 17, 2013 at 12:15 PM
Is it flashed to the newest firmwear? Also make sure you have everything properly connected. To be honest I HATE Xpresskit. I Love Idatalink. Swap it out and your golden.
Posted By: shortcircuit161
Date Posted: September 17, 2013 at 6:08 PM
x2 on using the idatalink modules versus Xpresskit!! You do need a dealer account to flash the idatalink modules, (or buy from someone that has an acct), but they are far superior to Xpresskits and can be programmed to work in data mode with the Viper system too.
The Cobalt uses an antitheft system called PK3+ which requires the correct resistance as well as the transponder info from the chip in the key to successfully start the car. It's possible one of those isn't correct from the Xpresskit (or didn't program/learn it right) and is triggering the antitheft system in the Cobalt.
-------------
Posted By: gberland
Date Posted: November 13, 2014 at 4:25 PM
Black piece of tape over the guage lok jk
|