new alarm not disarming from remote
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134806
Printed Date: May 12, 2024 at 1:13 PM
Topic: new alarm not disarming from remote
Posted By: shelby38
Subject: new alarm not disarming from remote
Date Posted: August 30, 2013 at 7:37 AM
I'm installing a new alarm in a 95 f150. Everything seems to be working correctly, doors lock & unlock, system arms, but when you press the unlock/disarm button and open the door the alarm goes office. When you close the door it stops. The door trigger is neg and the alarm lead is pos so I used a relay to reverse the polarity.
The truck wiring was a mess. 2 previous alarms were installed and left in place under the dash one partially disconnected and the other the fuse was pulled and siren wire cut. I removed both the systems before I started to install this new one.
Any thoughts on why the system doesn't disarm?
Replies:
Posted By: triniforever
Date Posted: August 30, 2013 at 8:01 AM
What brand of alarm are u using?
-------------
triniforever
Posted By: shelby38
Date Posted: August 30, 2013 at 8:20 AM
I think its AGPtek there no name on it.
Got it on ebay
https://www./itm/221059468686?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
Posted By: shelby38
Date Posted: August 30, 2013 at 8:22 AM
https://www./itm/221059468686?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
Posted By: shelby38
Date Posted: August 30, 2013 at 8:24 AM
Posted By: shelby38
Date Posted: August 30, 2013 at 8:49 AM
also I get 3 flashes of the lights when disarming
Posted By: offroadzj
Date Posted: August 30, 2013 at 11:10 AM
Is it the aftermarket alarm going off or the factory? Did you connect to the factory disarm or just the unlock?
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: shelby38
Date Posted: August 30, 2013 at 1:36 PM
There is no factory system.
If I disconnect the door trigger the unlock and lock work. Still get the 3 flashes on the like on the disarm/unlock.
When the door trigger is connected doors lock and unlock but when you open the door the alarm goes off even though the system has been disarmed from the remote. Pushing the disarm/unlock button doesn't stop the alarm from going off.
Posted By: racerjames76
Date Posted: August 31, 2013 at 8:08 AM
Wild stab in the dark but is the unit in some sort of valet mode? Hence maybe the extra light flashes? I buy from ebay but only new items from reputable manufacturers. Hate to condemn the unit but that is what i am leaning towards...  ------------- To master and control electricity is perfection. *evil laugh*
Posted By: shelby38
Date Posted: August 31, 2013 at 11:01 PM
Gave up and bought a different system and it installed fine and everything is working.
|
