lift gate trigger, 2003 jeep liberty
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134848
Printed Date: May 09, 2025 at 9:11 PM
Topic: lift gate trigger, 2003 jeep liberty
Posted By: nightowl2
Subject: lift gate trigger, 2003 jeep liberty
Date Posted: September 09, 2013 at 8:37 AM
I might not be searching for the correct term, but I have been looking all morning for a lift gate trigger, rear window trigger, or tail gate trigger for a 2003 Jeep Liberty. I do not have any clue what to wire up for the rear window or tail gate trigger. The only option I can think of is a hood pin trigger, but I do no want to drill into the metal to install that if there is a better way. I currently have not located a wire that changes in any way when either the window or the gate is opened.
What I am asking is: Is there a wire under the dash that monitors the tail gate or rear window?
Replies:
Posted By: chev104275
Date Posted: September 09, 2013 at 12:06 PM
Trunk/Hatch Pin tan/black - conn. 1, pin 7 @ BCM
The flip up glass pin switch is yellow/white in conn. 1, pin 9 of the BCM.
The BCM (Body Control Module) is attached to the left of the fusebox. Connector 1 is a gray 26 pin plug, and connector 2 is a gray 22 pin plug.
If your system doesn't have 2 negitive truck triggers you will need to split the 2 with diodes
-------------
If i Can't Install it I Don't need it Joe
|