clifford remote keyless entry system need
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134946
Printed Date: May 19, 2025 at 9:55 PM
Topic: clifford remote keyless entry system need
Posted By: monette999
Subject: clifford remote keyless entry system need
Date Posted: September 26, 2013 at 1:55 PM
Clifford Remote Keyless Entry System need PlainView coded valet switch schematic
Dear All,
My name is Bob
I have an old 1997 Clifford Remote Keyless Entry System which lost the memory
after disconnecting the battery.
I am trying to relearn the remotes but the system was delivered without the PlainView coded valet switch.
So I would like to build a switch. The switch is special.
Position 1) Latched
Position 2) Center
Position 3) Spring loaded momentary
Than there is an LED as well.
I have four wires 2 by 2 male connectors for the LED and Valet switch.
Connector one
Black ( Ground ) ?????? for LED & Valet switch
RED (12) 5A fuse
Connector two
White (Valet white)
Violet (LED violet)
I would be great if somebody could explain me the function of the PlainView coded valet switch schematic and how should I build a replacement switch.
What is the input and how to wire ground and 12V
Thank you in advance
Bob
Dear All,
My name is Bob
I have an old 1997 Clifford Remote Keyless Entry System which lost the memory
after disconnecting the battery.
I am trying to relearn the remotes but the system was delivered without the PlainView coded valet switch.
So I would like to build a switch. The switch is special.
Position 1) Latched
Position 2) Center
Position 3) Spring loaded momentary
Than there is an LED as well.
I have four wires 2 by 2 male connectors for the LED and Valet switch.
Connector one
Black ( Ground ) ?????? for LED & Valet switch
RED (12) 5A fuse
Connector two
White (Valet white)
Violet (LED violet)
I would be great if somebody could explain me the function of the PlainView coded valet switch schematic and how should I build a replacement switch.
What is the input and how to wire ground and 12V
Thank you in advance
Bob
Replies:
Posted By: monette999
Date Posted: September 27, 2013 at 10:16 AM