viper 5904v led
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134991
Printed Date: May 05, 2024 at 10:32 PM
Topic: viper 5904v led
Posted By: namyenruoj
Subject: viper 5904v led
Date Posted: October 02, 2013 at 10:32 AM
I just recenly finished installing a viper 5904V on my 91 celica. My LED from transponder was working fine las week and now it's not blinking at all when the system is armed. Is there a way to bring the light back again? Thanks
-------------
Replies:
Posted By: namyenruoj
Date Posted: October 02, 2013 at 10:37 AM
Everything works i can arm, disarm and remote start it no problem except the light
-------------
Posted By: lucasoil4u
Date Posted: October 02, 2013 at 3:36 PM
Did you check to insure that it is plugged in still?
Posted By: namyenruoj
Date Posted: October 08, 2013 at 5:55 PM
yah i made sure both side are plugged in still does not work
-------------
Posted By: namyenruoj
Date Posted: November 04, 2013 at 11:49 PM
i sent the tronsponder back and got a new one. i plugged it in the LED still does not blink or light up at all. what could it be the problem is there any alternative to add another LED in the system. thanks
-------------
Posted By: davep.
Date Posted: November 05, 2013 at 8:55 AM
how about test the LED? Keep in mind it is 2V. Unplug it from the module. Fab up some little jumpers. Use a AA battery as a power source. I don't know the polarity offhand, so try both polarities. If neither work, something has happened to the LED or the wiring to it.
Posted By: namyenruoj
Date Posted: November 06, 2013 at 12:17 AM
the wire cable between the unit and the trransponder 4 wires how can you check it for voltage
-------------
Posted By: namyenruoj
Date Posted: June 21, 2014 at 10:48 PM
Which wire is it from viper 5904v that will give out output voltsge upon disarming so i csn use it for my interior light
-------------
Posted By: howie ll
Date Posted: June 22, 2014 at 1:40 AM
Red (+) and pink (-) use a DMM or a 1.5 volt battery, AA. AAA.
If everything works, assume either the LED or the LED driver in the brain.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|