dball bypass programming fail

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135217
Printed Date: May 16, 2024 at 8:08 AM

Topic: dball bypass programming fail

Posted By: iono2013
Subject: dball bypass programming fail
Date Posted: November 05, 2013 at 1:29 PM

Hi all,

I have 2012 toyota camry with std key, after make the connection per wiring diagram manual that i download for my car and i check the connection seem to be correct, except i didn't connect the auto headlamp and park light wire. but when its come to programming the bypass on

step 6 :< size=2 face=ArialMT>< size=2 face=ArialMT>

Turn the ignition OFF and < size=2 face=ArialMT,Bold>< size=2 face=ArialMT,Bold>remove the key< size=2 face=ArialMT>< size=2 face=ArialMT>. The LED

keeps flashing green (quickly). Wait for the LED to flash

orange slowly (this may take up to 20 seconds). <======it's didn't do this and the led light went off completely.

does that's mean something not right or the module is bad?

Replies:

Posted By: blanx218
Date Posted: November 05, 2013 at 3:17 PM

Is the DBALL flashed with the 401.TL5 v1.02 firmware? You can also try resetting the module and starting over.

Posted By: iono2013
Date Posted: November 05, 2013 at 3:35 PM

I have the xkloader 2 and i try reflash a few time with the latest firmware avaiable for my vehicle and it still fail at the programming the module. if wiring not correctly it will show the error signal. but this one seem like bad module or d2d not communication or something. by the way i have it hooked up with viper 5701.

Posted By: blanx218
Date Posted: November 05, 2013 at 9:06 PM

I would triple check your connections, then try W2W