coil wire remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135388
Printed Date: May 13, 2024 at 6:16 PM

Topic: coil wire remote start

Posted By: fsask
Subject: coil wire remote start
Date Posted: November 26, 2013 at 10:12 PM

i have a 1993 nissan d21 2.4l 4 cyl auto putting ProStart CT3300 remote start in. some of my ignition switch wires are different colours than what i got from here. so i tested them to see which was which and got them hooked up . as per diagram from here i used white wire at coil and when attempting to start i get a code which says "a remote start was attempted while a tach-before-crank signal was detected before cranking" anyone know if maybe this isnt the right colored wire on my coil? anyway to test it to see? it also said i can use blue at ecu but i have a blue with silver slashes and a blue with red stripe any idea which one?
thanks for any help

Replies:

Posted By: kreg357
Date Posted: November 27, 2013 at 2:07 AM

Think in the U.S. market the 1993 D21 is known as Hardbody, Kingcab or Pickup. Here is some info from ReadyRemote and Bulldog:
Tach White (AC) @ large connector by driver kick panel

Use a Digital Multi Meter set to 20V AC, Black test lead on chassis ground and Red test lead on suspect wire to test. A reading
of 1 to 6 volts that rises with RPM's is normal. Not familiar with the CT3300 but if it has some sort of Tach Learn process, do
that and verify a good response.

-------------
Soldering is fun!

Posted By: fsask
Date Posted: November 28, 2013 at 1:07 PM

thanks kreg357 finally got it sorted on my truck needed to wire relay for cold start in order to work did that and reprogramed now works great