avital 5303
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135392
Printed Date: April 27, 2024 at 5:39 PM
Topic: avital 5303
Posted By: ktmrider
Subject: avital 5303
Date Posted: November 27, 2013 at 12:12 PM
I just bought a 5303L and installing it on my 1999 Tacoma. I have installed alarms, car audio products for a living, but it has been many years since I have and I am bit out of practice. My question is this:
The Avital came with a 504D shock sensor, and a plug in harness. However the harness has a green wire that is loose. I have read the instructions and I do not understand them. There is mention of a optional dual shock sensor,and a diagram to cutting a green wire, but it is already cut/loose. There is also a looped green wire on one end of the harness. I don't mean to seem like a idiot, but is not clear to me. Any help would be appreciated.
Thanks!
Replies:
Posted By: buddholly
Date Posted: November 27, 2013 at 12:59 PM
The green loop will go towards the 504D. The loose green wire will not be needed.
-------------
Posted By: ktmrider
Date Posted: November 27, 2013 at 1:32 PM
Just to be clear...leave loop intact plugged into the shock sensor. and isolate or cap off the loose green wire?
Posted By: buddholly
Date Posted: November 27, 2013 at 1:34 PM
Yep.
-------------
Posted By: ktmrider
Date Posted: November 27, 2013 at 1:40 PM
Thank you!
|