fortin evo all

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135461
Printed Date: July 14, 2025 at 6:54 PM

Topic: fortin evo all

Posted By: tonythetiger
Subject: fortin evo all
Date Posted: December 04, 2013 at 10:27 PM

If I use the evo-all bypass using wire2wire mode, do I need to hookup with the flasher updater to enable it W2W? I know D2D is enabled but I want to hard wire and I do not have a Flash updater at the moment.

Thanks

Replies:

Posted By: kreg357
Date Posted: December 04, 2013 at 10:42 PM

The EVO-ALL can go W2W without any special flash or set-up. Just follow the install guide and cut the D2D 4 Pin
cable, connect Red to +12V and Black to chassis ground and then make all the necessary hard-wired connections.

-------------
Soldering is fun!

Posted By: tonythetiger
Date Posted: December 04, 2013 at 11:10 PM

Thanks for the quick reply, yes the data wires were cut and pwr and ground have been connected

Print Page | Close Window