2001 gmc sierra 5.3 remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135470
Printed Date: May 15, 2024 at 7:33 PM
Topic: 2001 gmc sierra 5.3 remote start
Posted By: luis1221
Subject: 2001 gmc sierra 5.3 remote start
Date Posted: December 05, 2013 at 2:34 PM
Hello guys, I'm new here and I've been searching for my problem and couldn't find anything so I'm going to ask. Ok I have a 2001 gmc sierra and I am installing a python 5706 (should be that same as 5704) remote start/alarm. I was able to successfully install the alarm portion however, when I tried to start up the remote start I got an error on my remote followed by 8 flashes. I have identified that 8 flashes means that the neutral safety switch is off or that it has to do with neutral safety. As for the switch that goes in the brain I ran a loop so that the switch would always be in the "on" position. Now I'm not 100% sure if my wiring is right. Has anyone installed this alarm on the same vehicle or even the previous version? If so could you help me identify which wires are needed for remote start (colors, which pin they are located, what color wire they are to be connected to, and where the wire is located in vehicle) thanks in advance for those who help.
Replies:
Posted By: blanx218
Date Posted: December 05, 2013 at 3:39 PM
There is another wire for neutral safety that needs grounded. its a small BLACK/ white in the 18-pin harness
Posted By: luis1221
Date Posted: December 05, 2013 at 6:40 PM
I dont have an 18 pin, i have a 24 pin that is the Auxiliary/shutdown/trigger harness, there's the back and white wire that is the neutral safety/parking break input, i grounded this wire, there is a note that says "Ground this wire for automatic transmition or connect to the parking break wire for manual transmission vehicles." Thanks for the reply.
Posted By: luis1221
Date Posted: December 05, 2013 at 6:48 PM
Also idk if this would have to do with the problem but the orange and black wire (handbreak status output) in the red 12 pin harness that goes into my dball is suppose to go to my handbreak status input, which wire would that be in automatic?
Posted By: pentavolvo
Date Posted: December 05, 2013 at 7:18 PM
Ground it
Posted By: luis1221
Date Posted: December 06, 2013 at 10:37 AM
Yeah the black and white wire which I ground is grounded
|