2013 mazda cx9 not unlocking
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135552
Printed Date: May 10, 2024 at 12:44 PM
Topic: 2013 mazda cx9 not unlocking
Posted By: mb07
Subject: 2013 mazda cx9 not unlocking
Date Posted: December 16, 2013 at 1:17 PM
Just finished a 2013 Mazda cx9. Did a basic compustar CM6200 brain with a fortin key override all, if I lock with the Mazda fob, Remote start the car the compustar will not unlock the doors only the Mazda fob will but even that only unlocks the drivers door. If I lock with compustar and start it the compustar will unlock the doors no problem. Any help is appreciated. Yes I put the 1000 ohms resistor to the lock wire and both going to a violet /white in the car
Replies:
Posted By: mb07
Date Posted: December 16, 2013 at 5:12 PM
Solved. The problem was all wiring diagram charts say the lock and unlock on the Mazda is PURPLE / white which is correct except what the key override all diagram does not tell you is that you need to hook the door locks analog in this cars case it's light green in the same plug. The evo all diagram tells you this I don't know why override all doesn't
Posted By: Satkunas
Date Posted: December 16, 2013 at 7:51 PM
The KEY-OVERRIDE-ALL is only an immobilizer bypass module. It doesn't offer any features that interact with the vehicles convenience features such as door-locks etc etc. The EVO-ALL does however. Hence the differences.
Posted By: mb07
Date Posted: December 18, 2013 at 10:32 AM
Now my only one issue is with this vehicle having a smart key after walking away with the key the factory alarm will arm itself which causes the vehicles alarm to go off during remote start. The light green wire that the evo all diagram says that is the door locks in analog but wiring diagrams such as ready remote call it the disarm wire. How do I correct this alarm going off problem?
|