Hi Guys I had a dealer install an Avital 5303L. The remote start activates fine at times nut other times when its cold the crank time is too short.
How do I program to the crank time?
I read its .6 seconds I may want to up it to .8 seconds.
Also The user manual says remote start says * button once. but I have to press it twice. the other thing is sometimes it does not receive the signal even if im right next to the car.
I hate bringing it back to the installer because I dont like their service and attitude.
-------------
Larry
Hi Larry,
Sounds like you have a couple issues. Obviously the best route is going back to the dealer, but if you are somewhat
capable, you can correct these issues yourself.
You didn't mention the vehicle make, year & model. That info would help. Did you get any additional info about a
bypass module used ( if necessary ) ?
Here is a link to the 5303 install guide : https://www.the12volt.com/installbay/file.asp?ID=811
There are a couple of choices to make. My guess is that you are in Virtual Tach Mode. Personally, if it were my vehicle,
I would want to be in Tach Mode. It's just a matter of running one extra wire to a good Tach source and doing the Tach
Learn Process. Tach Mode will always get the engine started, no matter the temperature of how long the engine has been
off. Look at the programming tables, Menu 3 Items 1 and 4.
As for the two press start, that too is a programming option. See Menu 3, Item 5.
Be careful when changing these options with the remotes. If you get in the wrong menu option, you can foul things up.
-------------
Soldering is fun!
in Mn we do not connect hood pin becuase you will be coming back in 3 months wizzed off cause it doesnt work. We always always do an override switch though.
https://www.directeddealers.com/manuals/IG/Avital/N5303_2008_07web_.pdf
read this around page 40 it tells you how to access the features.
43 has cranking time but i always recommend hooking up tach so you dont have over crank conditions.