viper 5901 aux outputs

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135652
Printed Date: June 15, 2024 at 3:20 PM

Topic: viper 5901 aux outputs

Posted By: antonic
Subject: viper 5901 aux outputs
Date Posted: December 29, 2013 at 6:15 PM

Is there any problems using these outputs to run relays to fold/unfold side mirrors when arming and disarming instead of using Pulse Timer Relays 528Ts?

I would set them to Timed 30sec and link them to Arm/Disarm?

posted_image

Replies:

Posted By: freqsounds
Date Posted: January 11, 2014 at 6:26 PM

What is the year, make, model of the vehicle?

You can use an aux channel and link to arm and disarm, but I think 30 seconds would be too long. Unless it uses sensors that control the motors (meaning the BCM ultimately controls the fold in/out), I wouldn't hook it up. There may be a wire you can pulse to tell the car to fold them in or out.

Posted By: antonic
Date Posted: January 13, 2014 at 6:23 AM

The car is a 2002 Nissan Silvia(S15). I don't think there are any pulses to fold/unfold them automatically. Hence I have set up 2 relays to run the motors with -ve triggers.

You can set the time to 5s with a Bitwriter, doesn't have to be 30s.

Thanks.

Print Page | Close Window