Print Page | Close Window

code alarm ca 5050

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135759
Printed Date: May 11, 2024 at 11:21 PM


Topic: code alarm ca 5050

Posted By: Msp541
Subject: code alarm ca 5050
Date Posted: January 08, 2014 at 10:04 PM

Can anyone help me out with the installer guide for the Code Alarm CA-5050? I would greatly appreciate any help and help for programming 2 remotes to this unit.

Thanks again! posted_image

-------------
Thanks, Bri



Replies:

Posted By: lectricguy
Date Posted: January 08, 2014 at 10:24 PM

Install Manual link: https://documents.codesystems.com/710877.pdf


The transmitter programming is done as follows:

1. Turn the ignition ON (between Accessory & Start).
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp (3) three times.
4. Press 1 button of each transmitter you wish to program. (press the Lock button)
5. The system will respond with 1 chirp for each accepted transmitter.

NOTE: The system will exit transmitter programming after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programs all channels (buttons) of the system on a single press of the transmitter lock button.

NOTE: The system will hold up to 4 transmitters in memory, programming a 5th transmitter will erase the oldest transmitter in memory.

-------------
Lectric Guy


Print Page | Close Window