prostart ct 3371 on 04 ford freestar
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135829
Printed Date: July 07, 2025 at 11:52 AM
Topic: prostart ct 3371 on 04 ford freestar
Posted By: unterstrom
Subject: prostart ct 3371 on 04 ford freestar
Date Posted: January 14, 2014 at 11:04 AM
Hi guys, I am in need for some troubleshooting advice.
Have a prostart CT-3371 with an Xpresskit bypass installed on a 04 Ford Freestar. Wiring/programming seems to be done as per instructions and diagrams, but the van doesn't crank. The brake lights come on for a few seconds and that's it. No lights flashing an error sequence. Tried to remote start with the bypass disconnected and the key in ignition. Same scenario. Swapped the r/s for another unit, no change. Any hints?
Thanks
-------------
"Good judgment comes from experience. Experience comes from poor judgment."
-unknown
Replies:
Posted By: cutter122
Date Posted: January 14, 2014 at 1:39 PM
I can help you but missing information. What is the xpresskit you use and whitch programm sorry for my english loll
Posted By: chev104275
Date Posted: January 14, 2014 at 1:53 PM
Brake lights come on ? Something isn't right could you list out your connections for us. So we can get a better understanding of what's going on.
-------------
If i Can't Install it I Don't need it Joe
Posted By: unterstrom
Date Posted: January 14, 2014 at 1:57 PM
The bypass is a pkall (I think). The product number is 0340766. It came pre-programmed for the van.
What do you mean by which program?
Thanks,
-------------
"Good judgment comes from experience. Experience comes from poor judgment."
-unknown
Posted By: cutter122
Date Posted: January 14, 2014 at 2:04 PM
Can you give me your installation wirring?
Posted By: unterstrom
Date Posted: January 14, 2014 at 2:34 PM
Sorry guys, I don't have the diagrams on hand. Will post ASAP.
Thanks
-------------
"Good judgment comes from experience. Experience comes from poor judgment."
-unknown
Posted By: unterstrom
Date Posted: January 14, 2014 at 3:50 PM
I got a bit further. Forgot to cut the yellow wire loop to set it into automatic transmission. Now it starts with the key in ignition. Next will hook up the bypass. Will post if I run into trouble.
Thanks
-------------
"Good judgment comes from experience. Experience comes from poor judgment."
-unknown
|