2000 ford ranger remote start and now
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135936
Printed Date: July 14, 2025 at 9:23 AM
Topic: 2000 ford ranger remote start and now
Posted By: monty_77
Subject: 2000 ford ranger remote start and now
Date Posted: January 27, 2014 at 4:48 PM
Just installed a astrostart rs-721 with a idatalink tb in a 2000 ford ranger followed directwire for wiring and tested all wires with digital multimeter. Truck had no power door locks. Now customer is saying 4x4 is not working. My fault I did not test before. Where should u start if not fuses
Any help would be appreciated.
Replies:
Posted By: Ween
Date Posted: January 27, 2014 at 7:25 PM
Make sure the ignition switch wires are powered properly. Directwire shows that vehicle has one ignition, two accessory wires. Does the grey / YELLOW drop out when cranking? BLACK/ light green also? Does the 4x4 not work with either the key and remote start? Assuming it's a switch on the dash...is it plugged in?
Mark
Posted By: monty_77
Date Posted: January 27, 2014 at 10:04 PM
Yes all wire done and test before, pulled battery cable for ten min put back on then everything was working, not sure what it was
|