viper 5706v,dball2, 2010 tacoma
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135992
Printed Date: July 07, 2025 at 2:19 AM
Topic: viper 5706v,dball2, 2010 tacoma
Posted By: helidave
Subject: viper 5706v,dball2, 2010 tacoma
Date Posted: February 04, 2014 at 5:11 PM
Getting ready to install a Viper 5706V and DBALL2 in a 2010 Tacoma, AT, dot-key.
Will the DBALL2 do anthing besides immobilizer bypass in this vehicle?
What I really want to know is if using the DBALL2 will change the wiring required for the 5706 (door locks, brake pedal, tach, etc)
Here are the functions the DBALL2 can perform in a 2010 Tacoma according to xpresskit.com:
D2D
PK-Immobilizer Bypass-Data No Key Req'd
ST-Brake Status (foot brake)
ST-Hand Brake Status
ST-Hand Brake Status
ST-Ignition Status
Replies:
Posted By: helidave
Date Posted: February 04, 2014 at 7:46 PM
If someone can double check my connections I would appreciate it.
 
Posted By: freqsounds
Date Posted: February 04, 2014 at 8:20 PM
helidave wrote:
Getting ready to install a Viper 5706V and DBALL2 in a 2010 Tacoma, AT, dot-key.
Will the DBALL2 do anthing besides immobilizer bypass in this vehicle?
What I really want to know is if using the DBALL2 will change the wiring required for the 5706 (door locks, brake pedal, tach, etc)
Here are the functions the DBALL2 can perform in a 2010 Tacoma according to xpresskit.com:
D2D
PK-Immobilizer Bypass-Data No Key Req'd
ST-Brake Status (foot brake)
ST-Hand Brake Status
ST-Hand Brake Status
ST-Ignition Status
The DBALL will eliminate all those wires. Hook up the HSCAN wires and the RX/TX wires to the immobilizer and you're good to go.
All these power, status, triggers, etc. are communicated over the HSCAN. It's like a network.
Just make sure the DBALL is updated to the latest firmware via the XKLoader2. Read the entire manual for the DBALL and you should be good to go! ------------- No question is stupid or not worth asking. You were once a noob, right? :)
Posted By: helidave
Date Posted: February 04, 2014 at 9:15 PM
freqsounds wrote:
The DBALL will eliminate all those wires. Hook up the HSCAN wires and the RX/TX wires to the immobilizer and you're good to go.
All these power, status, triggers, etc. are communicated over the HSCAN. It's like a network.
Could you be more specific about which wires I can leave off the alarm? It looks like it can do a lot, but for my vehicle it will only send brake, handbrake, and ignition status to the alarm/rs.
|