Compustar CM6000 Wiring, Program Failure

I have a Compustar 6000as Module, Blade AL and 2w901SS Remote with the EZGO and RPS-Touch and Drone 3100 Options in a 2006 GMC Envoy Denali. Blade Module was update via idatalink site and specified all option I wanted. Connected to vehicle and programmed the module which went perfect, Blue light on Blade came on Solid then went out. Remote Start and Door Locks work w/ Arm and Disarm. I cannot get my remote to enter into any of the Option 1,2,3,4 Menu's to change settings like Auto Lock for the EZGO, nor can I get the RPS touch to program, It illuminates when touched though. Am I missing a connection like the (-)GWR or (-)Door Pin Trigger which I thought is covered by the Blade. Here are my connections. CN1 Connector is complete, CN3 Connector wired for #'s (1),(6),(7)to relay "Violet",(16)"Tach", (17), (18), (20) all connected, CN4 Connector "Blade" Orange wire to # 2 on OBDII Diagnostic Port, that's all. CN6 Connector is not wired. All other accessories are plugged in. I noticed the LED stays solid when the vehicle is off and blinks when armed, It never goes out. Can you let me know if I am missing some connections or if there is a programming issue. I attached as many diagrams as I had and paid for online.