problem with viper 5704v nss remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136014
Printed Date: May 14, 2025 at 5:23 PM
Topic: problem with viper 5704v nss remote start
Posted By: ubnpast
Subject: problem with viper 5704v nss remote start
Date Posted: February 07, 2014 at 3:09 PM
This Viper 5704v was installed into a 2004 Honda CRV(this unit replaced a UltraStart System), it is paired with a Fortin SL3 transponder bypass.
I am getting 8 flashes which is a error for " Neutral safety wire has no ground or the neutral safety switch is Off"
I have checked multiple times, the wire is grounded (tested with light and also tried other locations. The NSS Toggle Switch is also "on" (both wires are seeing a ground).
Note: This CRV is an automatic, and this option was changed in the menu settings.
What are some other causes of this? Bad Brain?
Replies:
Posted By: smokeman1
Date Posted: February 07, 2014 at 8:10 PM
Loose pin, loose connector not seated, loose wire, bad brain.
Do you have another brain on hand to switch out?
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: ubnpast
Date Posted: February 08, 2014 at 8:30 AM
smokeman1 wrote:
Loose pin, loose connector not seated, loose wire, bad brain.
Do you have another brain on hand to switch out?
All pins are seated, connections are good tested with light.
I don't have another brain to test it out, may have to see if it can be exchanged for another.
|